1 automatic width measurement – CEMB USA ER85 (A) User Manual

Page 12

Advertising
background image

12

FI

FE

FI

Pos B

Pos A

Use and maintenance manual Rev. 09-2013

ENGLISH

a) Standard weight
Using the special grip, move the end of the gauge against
the rim in one of the positions A/B shown.

b) Adhesive weight: in the position indicated below.

INdIcATIoN

always use the round part of the striker plate

Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (

ACOUSTIC SIGNAL

),

the acquisition of the dimensions is accompanied by a “beep”.

Set the distance+diameter gauge to the rest position.

The other enabled buttons are:

This button is used to improve the dimensional

calibration of large-diameter wheels such as off-

road, trucks, wheels which protrude significantly

from the rim. Press this button several times to

select the type of tyre projection (from 1.0” to

2.0”). The option is disengaged at the end of current

Width Measurement.

selecting the manual dimension presetting screen

5.2.1.1 Automatic width measurement

Slowly lower the guard after making the automatic measu-
rement of the distance + diameter to automatically measure
the wheel width.
If the width measured is incorrect (out of range), the following
message appears:

“Sonar measure is out of range:”

= repeat”

= manual set-up”

Press

to re-lower the guard and repeat the width

measurement. Press

to go to the dimensions panel

for manual insertion of the width measurement. Manually
presetting is possible by using the push buttons as described
in

PRESETTING OF WHEEL DIMENSIONS”.

5.2.2 ALUS wheel automatic presetting (adhe-

sive weights)

Make two consecutive measurements inside the rim on
two correction planes of your choice as indicated in figu-
re. When the acoustic signal is enabled (

ACOUSTIC

SIGNAL

), the acquisition is accompanied by a “beep”.

The enabled buttons are:

user call/save control

selecting the manual dimension presetting
screen

return to initial screen.

Close the guard to perform a balancing spin.

Position of adhesive weights

Use of the wheel balancer

select the type of weight to

apply (

CORRECTION

METHODS

).

return to initial frame

Close the guard to perform a balancing spin.

Position of adhesive weights

Advertising
This manual is related to the following products: