CEMB USA ER85 (A) - Manual (Page 23)

23
Use and maintenance manual Rev. 09-2013
ENGLISH
8. To obtain an overview of the wheel balancing values,
press the symbol.
A window appears:
Setup
This function allows balancing the four wheels of a vehicle, plus
the spare wheel if necessary, and obtaining the information
on how to fit these wheels on the vehicle in such a way that
the vibrations due to residual eccentricity of each wheel is
reduced to a minimum. The ‘TYRE TRAIN’ function can be
enabled and disabled from the MENU (
MENU ACCESS
DIAGRAM ). For best use of this function proceed as follows:
AUTOMATIC TYRE SET
1. Prepare numbered stickers to identify the wheels.
2. Press the button to start the procedure.
3.
Mount the first wheel and correctly position the radial
and lateral eccentricity measurement sonars.
4. Balance the wheel and identify it with number 1.
5. Repeat steps 3 and 4 for the remaining three wheels,
plus the spare wheel if necessary, each time identifying
the wheel with a progressive number from 2 to 5.
6. Each time the spindle is opened, the wheel balancer
highlights the best fitting solution for the wheels balan
ced
up to that moment. The centre of the screen shows
an outline of the vehicle with the four tyres plus
the spare; each time you spin a wheel, the number
of the wheel to be fitted in each position on the vehicle
is indicated (front/rear axles and right/left).
7. The procedure can be reset at any time by pressing the
button .
If the spindle is opened incorrectly, the balancing sequence
is interrupted and, consequently, the end result will be
incorrect.
MANUAL TYRE SET
1. Gather together adhesive symbols to identify the
wheels.
2. Press and to start the procedure.
3. Fit the first wheel and place the radial eccentricity
measurement sonar in the correct position.
4. Balance the wheel, identify it using the number 1
and press .
5. Repeat points 3 and 4 for the other three wheels
and identify the wheels using the numbers 2, 3 and 4.
6. Each time data is saved, the balancing machine
highlights the best fitting solution for the wheels
balanced up to that moment.
7. The middle part of the screen shows a stylised
vehicle with four tyres; at each spin the number of
the wheel to be fitted in each position (rear/front
axle left/right) is indicated on each of the tyres.
The procedure can be rest at any time by pressing
and .
The following buttons are enabled:
to return to the measurement screen
resets the tyre set
saves the tyre (only if Tyre Set = manual)
7.6.7 Weight statistics
If enabled, it allows saving the weights used to balance the
wheels (
WEIGHT STATISTICS SCREEN ); this function
can be disabled by setting it to “OFF”.
7.6.8 User
Enables/disables user selection display.
7.6.9 Date
Enables/disables date display.
7.6.10 Time
Enables/disables time display.
7.6.11 Icon
Enables/disables status icon display.
7.6.12 LT automatic
If set to ON, the wheel bulges are automatically calculated;
the calculated value can however be modified by pressing
the button .