CEMB USA C71 (C) - Manual (Page 5)

Spring
DC WD Cone
3a
4
1 2
3 4
6
7
8
9
10
11
12
13 14
5E 5I
15
I 0410 - 4 I 0410 - 5 GB GB
3.5 - WD spacer
4 - Controls and components
4.1 - Automatic distance and diameter gauge
Allows automatic measurement of the distance from the machine and the wheel diameter at the counterweight
application point. The same gauge can be used to position the counterweights correctly inside the wheel, using the
specific function that suggests the position memorised during measurement inside the rim.
4.2 - Keyboard and display
To move the wheel away from the machine side (e.g. for
very wide wheels), fit the WD spacer on the flange body
and secure it with the standard issue nuts. When centring
the wheel with cone from the inside, mount the DC spacer
to obtain spring thrust. These devices are optionals (see
flange details enclosed).
1-2 Digital readouts, AMOUNT OF
UNBALANCE, inside/outside
3-4 Digital readouts, POSITION OF
UNBALANCE, inside/outside
5I INSIDE correction position selection button
5E EXTERNAL SIDE and STATIC correction
position selection button
6 Push button, FUNCTIONS MENU
7 Push button, MENU selection confirmation
8 Maximize/MENU button
9 Minimize/MENU button
10 Push button, unbalance reading < 5 g
(.25 oz)
11 Push button, SPLIT (unbalance spread)
12 Position repeater push button
13 Push button, cycle start
14 Push button, emergency/home
15 Dot matrix function display
Note: - Press buttons only with your fingers. Do not use the counterweight grippers or other pointed
objects.
RED
GREEN
YELLOW