CEMB USA C71 (C) - Manual (Page 8)

6
I 0410 - 8 I 0410 - 9 GB GB
5.2.1.1 - Static & combined modes
After calibration as per STEEL OR ALUMINUM WHEEL RIMS. SPRUNG COUNTERWEIGHTS , it is possible to modify the
position of the correction weights using the ALU buttons.
STATIC: Select by pressing ALU (5E)
Balancing of light alloy rims with application of adhesive weights
on the shoulders of the rims.
Combined balancing: adhesive weight on the outside and clip-on
weight on the inside.
Combined balancing: adhesive weight on the inside and clip-on
weight on the outside.
5.2.2 - Rims with internal counterweight
Slide out the gauge on the LH side, at the point where a weight is
to be fitted. Wait for the “beep”. Slide it out further towards the RH
side and wait for a second “beep”. The wheel balancer
automatically identifies ALU S mode.
Counterweight position automatically suggested .
ALU (5I) can be used to set the alternative position indicated.