CEMB USA C71_2 evo (E) - Manual (Page 17)

17
40
m
m
Use and maintenance manual Rev. 01-2010
ENGLISH
6.6.2 Diameter gauge
E
Display the SETUP menu
P 1. ress to view the diameter
gauge CALIBRATION function.
m
Place the round part of the gauge terminal on the
flange as shown in the figure and press
Th 2. e number 354 ± 3° appears on the left display .
Turn 3. the gauge downward position the round part
of the gauge terminal at 40 mm (radial distance)
from the flange as indicated in the figure; alternati
vely use one of the cones provided as shown in the
images
The nu 4. mber 254 ± 3° should appear on the left
display. The calibration is already correct.
If not, press the button holding the gauge still at 40
mm: the number 254 appears on the left display.
Return the gauge to rest position.
6.6.3 Width sonar (option)
Display the SETUP menu
P 1. ress to view the width sonar
CALIBRATION function.
Set with 2. the distance in mm betwe
en the Sonar sensor (0 sonar) and t he end of the
distance gauge (at rest).
A = Distance: Gauge at rest to 0 sonar
In the event of incorrect input in the width gauge calibration
function, press to cancel it.
Setup