CEMB USA T1-38 T1-38BF T1-38V - Manual (Page 6)

Technical data
Electrical connection
The connection cable should be shielded, bipolar type with
minimum cross section of 1 mm 2 , joined to the connector supplied
as standard with the transducer (model T1-40) or else directly fitted
to the transducer (model T1-38).
Mounting
The transducer should be fitted by tapping a hole at the point where
it has to be fixed. If this is not possible, apply a block with tapped
hole on the machine support. The use of adhesive is advisable
when tightening the transducer.
CEMB also manufactures
• Universal horizontal balancing machines with coupling and/or belt
drive for balancing rotors from 10 g to 100.000 Kg.
• Vertical balancing machines for balancing rotors from 50 g to 1500
Kg on 1 or 2 correction planes.
• Special purpose balancing machines for complete assemblies.
• Special purpose balancing machines including various types of
units for correcting unbalances semi-automatically or automatically.
• Portable equipments for measuring and analyzing vibrations as well
as balancing under service conditions.
• Fixed supervisory and testing equipment for continuous monitoring
of large scale plants with rotating machines (turbines, pumps,
compressors) including checking for vibrations, displacements,
deformations, eccentricity, etc.
and offers the following services:
• Balancing on a contract work basis
• Vibration analysis on a contract work basis
• Periodic maintenance data acquisition service
• Training courses in balancing and vibration technology at CEMB
or customer’s premises
• Specific technical booklets on balancing and vibration technology
are available upon request, free of charge:
Booklet N.2 - “Mechanical vibration technology”
Booklet N.3 - “Balancing technology”
Booklet N.8 - “Accuracy in balancing rigid rotors”
Booklet N.10 - “Balancing of flexible rotors”
Booklet N.11 - “Testing of balancing machines”
Booklet N.17 - “Theoretical principle of wheel balancing”
Booklet N.18 - “Wheel balancing”
Booklet N.19 - “Crankshaft balancing”
Booklet N.20 - “Balancing under service conditions”
Booklet N.23 - “Testing of vibrations in machines during service”
Booklet N.24 - “Machinery monitoring and
supervisory instrumentation”
Booklet N.26 - “Protection of balancing machines”
Safety precautions and devices for use
on balancing machines
Booklet N.27 - “Choice of a balancing machine”
All the data and features mentioned in this catalogue are purely for information and do not
constitute any commitment on the part of our company, which reserves the right to make any and
all alterations it may consider suitable without notice.
A
T5001420 06/08
CEMB S.p.A.
Via Risorgimento, 9
23826 Mandello del Lario (LC) Italy
www.cemb.com
Vibration analysis division:
phone +39 0341 706111
fax
+39 0341 706299
[email protected]
B A L A N C I N G M A C H I N E S