CHIEF NW2 Series User Manual
Page 9
Installation Instructions
NW2F8-12
9
Attaching Door
NOTE:
The door may be attached on either the left or right of
the rack.
1.
Rotate two spring handles (one at bottom and one at top) on
inside of door. (See Figure 9)
Figure 9
2.
Pull down on upper spring handle, and push up on lower
spring handle. (See Figure 9)
3.
Insert door into rack, aligning the spring handle ends with
the holes in the top and bottom of rack. (See Figure 10)
Figure 10
4.
Add one end of rack wire (N) to grounding stud at bottom of
door. (See Figure )
5.
Tighten 1/4-20 nut (L) onto grounding stud. (See Figure )
6.
Place opposite end of rack wire to grounding stud on floor
of rack. (See Figure )
7.
Tighten 1/4-20 nut (L) over rack wire and onto grounding
stud. (See Figure )
Figure 11
Upper
spring
handle
Lower
spring
handle
1
2
Door
attachment
holes
5
6
(L) x 2
(N)
7
4