Assembly – CHIEF ECRR Series User Manual
Page 5
Installation Instructions
ECRR Series
5
ASSEMBLY
1.
Use four #10 x 5/8" wood screws (R) to secure two rack rails
(E) to two side panels (A and B). (See Figure 1)
Figure 1
2.
Screw seven connecting bolts (V) into each side panel (A
and B). (See Figure 2)
Figure 2
3.
Install six cams (M) into holes on rack top (C) and rack
bottom (D). (See Figure 3)
4.
Install two cams (M) into holes on back support (F). (See
Figure 3)
Figure 3
5.
Place one side panel (A or B) on flat surface with connecting
bolts (V) facing up. (See Figure 4)
6.
Drop rack top (C), rack bottom (D) and back support (F)
onto side panel with cams (M) engaging with connecting
bolts (V). (See Figure 4)
NOTE:
Make sure the caster holes on the rack bottom are on
the bottom and that the rack top has no holes facing up.
7.
Turn all cams clockwise to secure side panel. (See Figure 4)
8.
Drop other side panel (A or B) onto rack top (C), rack bottom
(D) and back support (F) with cams (M) engaging with
connecting bolts (V). (See Figure 4)
9.
Turn all cams clockwise to secure side panel. (See Figure 4)
Figure 4
(R) x 4
(A)
1
(B)
(E) x 2
(V) x 7
2
(V) x 7
2
(B)
(A)
(M) x 6
(M) x 6
(M) x 2
3
3
4
(B)
(F)
(C)
(D)
(A)
6
8
7
(M) x 7
9
(M) x 7
caster
holes