CHIEF ECRR Series - Manual (Page 7)

Installation Instructions ECRR Series
7
17. Use pre-installed screws to attach two mounting plates (U)
to side panel where door hinges will be installed. (See
Figure 9)
18. Use two #10 x 5/8" wood screws (R) to attach strike plate
(K) to opposite side panel. (See Figure 9)
Figure 9
19. Connect clip-on hinges (P) to mounting plates (U) by
following these three steps:
• a. Place hinge on mounting plate making sure
front tabs latch onto front end of plate. (See
Figure 10)
• b. Pull up lever on end of hinge. (See Figure 10)
• c. Wrap hinge around plate and release lever.
(See Figure 10)
Figure 10
20. Install round grommet (H) into hole on rack bottom (D). (See
Figure 11)
Figure 11
21. Use 16 #10-5/8" wood screws (R) to secure four casters (N)
to to rack bottom. (See Figure 12)
Figure 12
(U) x 2
(K)
(R) x 2
17
18
(rack top not
shown for clarity)
a
b
c
(P)
(U)
(H)
(D)
20
(N) x 4
21 (R) x 16