CHIEF FSA1015 - Manual (Page 4)

Model: FSA-1015 Installation Instructions
4
ASSEMBLY (PART 1)
1. Determine location of bracket (10) in equipment rack.
Location is adjustable in 1" increments from
approximately 6" depth (within rack) to 1" extension
(in front of rack). Consider the following items:
•
Size of display: If display width (i.e., width of case,
not screen size) is greater than 17" then bracket
(10) must be mounted in front of OR flush with
equipment rack. If display width is 17" or less then
bracket (10) may be mounted at any location.
• Depth of mount and/or interface (if used).
• Extent of pitch, roll, yaw, height, and/or extension
desired (as applicable for each mount).
2. Using Phillips screwdriver, install screws (50) through
brackets (20) into desired threaded holes in bracket
(10) (See Figure 2)(See Figure 3). Ensure brackets
(10 and 20) are oriented as shown. Tighten screws
(50).
Figure 2: Install Side Brackets - 6" Depth
Figure 3: Install Side Brackets - 1" Extension
3. Proceed to "INSTALLATION."
INSTALLATION
Determine how display is to be installed to FSA-1015.
Four installation options exist:
• OPTION "A" - Installation without Existing
Wall Mount:
NOTE: This option REQUIRES a display having
mounting holes that are flush with the back
surface AND where access to the back of the
equipment rack is possible. If one or both of
these requirements are not met, proceed to
OPTION "B" below.
Applicable to VESA compliant display (75x75mm,
100x100mm, or 100x200mm mounting hole
pattern). Non-VESA compliant display also
requires installation of interface (purchased
separately; contact Chief Manufacturing at 1-800-
582-6480 for more information).
• OPTION "B" - Installation without Existing
Wall Mount:
Applicable to VESA compliant display (75x75mm,
100x100mm, or 100x200mm mounting hole
pattern). Non-VESA compliant display also
requires installation of interface (purchased
separately; contact Chief Manufacturing at 1-800-
582-6480 for more information).
• OPTION "C" - Installation with Existing FWD
Cynergy Wall Mount:
Applicable to VESA compliant display (75x75mm
or 100x100mm mounting hole pattern). Non-
VESA compliant display also requires installation
of interface (purchased separately; contact Chief
Manufacturing at 1-800-582-6480 for more
information).
• OPTION "D" - Installation with Existing FSR or
FTR Fusion Wall Mount:
Requires installation of interface (purchased
separately; contact Chief Manufacturing at 1-800-
582-6480 for more information).
INSTALLATION OPTION "A"
1. Install interface to display, if required. See
instructions supplied with interface.
2. Proceed to "ASSEMBLY (PART 2)."
3. Carefully place display face down on protective
surface.
CAUTION: Using screws of improper size may
damage your display! Proper screws will easily and
completely thread into display mounting holes.
4. Using Phillips screwdriver, install two (or three, if
applicable) screws (90) completely into the upper
display mounting holes, then back out 4 full turns (See
Figure 4).
NOTE: Do NOT install screws (90) into the lower display
mounting holes at this time.
10
20
50
(4 places)
(2 places)
10
20
50
(4 places)
(2 places)