CHIEF FSA1015 - Manual (Page 5)

Installation Instructions Model: FSA-1015
5
Figure 4: Install Upper Display Screws - Flush Mount
5. Pick up and orient display/interface so that the screws
installed in the previous step fit into the upper
mounting holes in bracket (10) (See Figure 5). Lower
display firmly into place.
Figure 5: Install Display - Flush Mount
6. From the back of the equipment rack, and using
Phillips screwdriver, install remaining two (or three, if
applicable) screws (90) through bracket (10) into the
lower display mounting holes (See Figure 5).
7. Tighten all four (or six, if applicable) screws. Do not
overtighten!
8. Install all cables.
9. Installation is complete.
INSTALLATION OPTION "B"
1. Install interface to display, if required. See
instructions supplied with interface.
2. Carefully place display face down on protective
surface.
3. Determine depth of mounting holes relative to the
back surface of display.
4. Select proper length spacer and screw from table
below:
NOTE: All spacers used should be the same length. If
recess depths result in multiple spacer lengths,
then select the longer spacer.
5. Place the selected spacers over each of the mounting
holes on the back of the display.
6. Pick up and orient the FSA-1015 assembly such that
the mounting holes in bracket (10) are aligned with
the holes in the spacers (See Figure 6).
Figure 6: Install Display - Recessed Mount
CAUTION: Using screws of improper size may
damage your display! Proper screws will easily and
completely thread into display mounting holes.
7. Using Phillips screwdriver, install four (or six, if
applicable) of the selected screws through the
mounting holes in bracket (10), through the spacers,
into the display.
8. Tighten all four (or six, if applicable) screws. Do not
overtighten!
9. Proceed to "ASSEMBLY (PART 2)."
10. Install all cables.
11. Installation is complete.
UP
90 (2 places shown; 3 places similar)
Display
90 (2 places shown;
3 places similar) 10
Display
IF recess DEPTH is: THEN use spacer: AND screw:
More than zero up to
and including 3/8" 120 (3/8" long) 100 (M4 x 20mm)
More than 3/8" up to
and including 3/4" 130 (3/4" long) 110 (M4 x 30mm)
NOTE: 100x100mm
VESA mounting hole
pattern shown; 75x75mm
and 100x200mm pattern
Display
FSA-1015
Assembly
100 or 110
120 or 130
(4 places)
(4 places)
similar.
10