CHIEF FSA1015 - Manual (Page 6)

Model: FSA-1015 Installation Instructions
6
INSTALLATION OPTION "C"
1. Install interface to display, if required. See
instructions supplied with interface.
2. Using Phillips screwdriver and 7/16" wrench, install
two screws (60) through #10 washers and wall
bracket (supplied with FWD mount), FSA-1015
assembly, and bracket (80), into nuts (70)(See Figure
7). Tighten screws (60).
Figure 7: Install FWD Wall Bracket
3. Proceed to "ASSEMBLY (PART 2)" below.
4. Install display to wall mount. See instructions
supplied with FWD mount.
5. Install display/wall mount assembly to wall bracket
(now installed in equipment rack). See instructions
supplied with FWD mount.
6. Install all cables.
7. Installation is complete.
INSTALLATION OPTION "D"
1. Install interface to display. See instructions supplied
with interface.
2. Using Phillips screwdriver and 7/16" wrench, install
four screws (50) through wall mount and bracket (10),
into nuts (70)(See Figure 8)(See Figure 9). Tighten
screws (50).
Figure 8: Install FSR Wall Mount
Figure 9: Install FTR Wall Mount
3. Proceed to "ASSEMBLY (PART 2)" below.
4. Install display to wall mount (now installed in
equipment rack). See instructions supplied with
FSR/FTR mount.
5. Install all cables.
6. Installation is complete.
80
60 (2 places)
70
(2 places)
FSA-1015
Assembly
FWD
Wall Bracket
#10 Washers
(2 places)
50 (4 places)
70 (4 places)
FSR
Mount
Wall
10
50 (4 places)
70 (4 places)
FTR
Mount
Wall
10