Warning, Caution – AAON CC-063 User Manual

Page 6

Advertising
background image

6




























































































GROUNDING REQUIRED


All field installed wiring must be
completed by qualified personnel.
Field installed wiring must comply
with NEC/CEC, local and state
electrical code requirements. Failure
to follow code requirements could
result in serious injury or death.
Provide

proper

unit

ground

in

accordance

with

these

code

requirements.

WARNING


During installation, testing, servicing
and troubleshooting of the equipment
it may be necessary to work with live
electrical

components.

Only

a

qualified

licensed

electrician

or

individual properly trained in handling
live

electrical

components

shall

perform these tasks.

Standard

NFPA-70E,

an

OSHA

regulation requiring an Arc Flash
Boundary to be field established and
marked for identification of where
appropriate

Personal

Protective

Equipment (PPE) be worn, should be
followed.

WARNING


UNIT HANDLING


To prevent injury or death lifting
equipment capacity shall exceed unit
weight by an adequate safety factor.
Always test-lift unit not more than 24
inches high to verify proper center of
gravity lift point to avoid unit damage,
injury or death.

WARNING


ROTATING COMPONENTS


Unit contains fans with moving parts
that can cause serious injury. Do not
open door containing fans until the
power

to

the

unit

has

been

disconnected and fan has stopped
rotating.

WARNING


Door

compartments

containing

hazardous voltage or rotating parts
are equipped with door latches to
allow locks. Door latches are shipped
with nut and bolts requiring tooled
access. If you do not replace the
shipping hardware with a pad lock
always re-install the nut & bolt after
closing the door.

CAUTION


Rotation must be checked on all
MOTORS AND COMPRESSORS of
3 phase units at startup by a qualified
service

technician.

Scroll

compressors are directional and can
be damaged if rotated in the wrong
direction. Compressor rotation must
be checked using suction and
discharge gauges. Fan motor rotation
should

be

checked

for

proper

operation. Alterations should only be
made at the unit power connection

CAUTION

Advertising
This manual is related to the following products: