ALLIED Vision Technologies Prosilica GT6600 - Manual (Page 59)

Camera interfaces
AVT Prosilica GT Technical Manual V2.1.0
59
Gigabit Ethernet port
The Prosilica GT is powered through the 12-pin Hirose Camera I/O port, or the
Gigabit Ethernet port by using any standard Power over Ethernet (PoE) sup-
ported network card, switch, or injector. AVT recommends using Category 6 or
higher compatible cabling for best performance.
www

The AVT GigE Installation Manual offers detailed instructions
for using Prosilica GT cameras.
http://www.alliedvisiontec.com/fileadmin/content/PDF/
Products/Technical_Manual/GigE_Install_Manual/
AVT_GigE_Installation_Manual.pdf
www

See Hardware Selection for AVT GigE Cameras application
note for a list of recommended Ethernet adapters:
http://www.alliedvisiontec.com/fileadmin/content/PDF/
Support/Application_Notes/
Hardware_Selection_for_AVT_GigE_Cameras.pdf
Note

A standard Ethernet adapter is available for purchase from AVT:
AVT P/N: 02-3002A
Model: Intel Pro 1000/PT
A dual port PoE Ethernet adapter is available for purchase from
AVT:
AVT P/N: 2685
Model: Adlink GIE62+
Note

Cable lengths up to 100 m are supported.
The 8-pin RJ-45 jack has the pin assignment according to the
Ethernet standard (IEEE 802.3 1000BASE-T).
Note

Prosilica GT cameras support cables with horizontal locking
screw connector for a secured connection (see figure 43).
AVT recommends using locking-screw cables from Components
Express, Inc. for a perfect fit. Visit the
CEI product configurator
to customize the cable according to your needs.