Analog Way Eikos2 - Manual (Page 60)

60
8.2.21 Capturing an animated logo
Logo capture is limited in the number of pixels being captured. When the logo capture area is resized, exten-
ding the horizontal size may reduce the vertical size to compensate.
Logos can also be captured and displayed with transparent areas. By adjusting the keyer in the logo capture
menu, the portions of the captured area can be keyed away and captured as transparent.
The logo “Cut out color” can help display which portions of the image will be captured as tranparent.
NOTES:
• The cut out color is only a visual tool to help identify the transparent areas of the logo. These colored re-
gions will not be captured but later displayed as transparent area.
• Capturing a “logo” is limited to a small percentage of the output resolution. To capture and display a full
screen image, use the still “frame”.
8.2.21 Capturing an animated logo
To capture animated logo, display the exact content you want to save on the Program screen, you can use the
freeze button. Then follow this step:
Logos/Frames menu > Record Anim menu > Set up your Anim > Store menu > logo#
To set up your animation, you have several features available:
- Position / Size Adjustment
- Keying type
- Luma / Chroma key
- Recording time
- Cut out color
Select the animated logo #8 and wait until the unit finishes saving. Your animation is now saved and you can
use it through the background logo button.
Only one animated logo can be saved in the Eikos².
8.2.22 Logos input setup menu
In the logos/frames menu, the logos can be deleted in the Erase menu:
Logos/Frames menu > Erase menu > Select Logo#
8.2.23 Working with logos
A simple or animated logo can be manipulated through the front panel. On the front panel, the logo# are
associated to the input# respectively. To assign a logo# to the logo layer:
Press Logo1 Layer button > Press Input#
Logos #1 to #8 are available directly by the input # button on the front panel.
You can change logos or delete logos on the Preview screen using the same way the layers do:
- Clear: Press Logo (#1 or #2) button > Press Black
- Change: Press Logo (#1 or #2) button > Press another Input#
8.2.24 Logos as layer
Logos are under the layer rules, you will have direct access to settings by pressing the logo layer button. You
have 2 logos layers buttons available.
You can use the Pos/Size/Zoom adjustment button and the Effect button from the front panel too.