Analog Way Smart Edge FX - Manual (Page 40)

38
Select the logo number you want to save and wait until the unit finish saving. Your logo is now saved and you
can use it through the background logo button.
You can save up to 4 logos with the STE200.
The capture of logos can be done only with the following conditions:
- The disappearance of logos on Main output is normal when saving logos.
The logos are captured with the same size as is visible on the Main output without any form of adjustments.
If zooming is required resize the PIP or use the layer or input zoom.
A logo captures the state of the defined area on the specified output at the Main output resolution, and must
be recalled using the same output resolution. Resizing or other image manipulation of the captured logo is
not possible.
The capture zone is outlined by a white rectangle and includes the pixels beneath the white border. The non-
captured area is reduced in brightness.
Logo capture is limited in the number of pixels being captured. When the logo capture area is resized,
extending the horizontal size may reduce the vertical size to compensate.
Logos can also be captured and displayed with transparent areas. By adjusting the keyer in the logo capture
menu, the portions of the captured area can be keyed away and captured as transparent.
The Logo “Cut out color” can help display which portions of the image will be captured as tranparent.
* NOTE *: The cut out color is only a visual tool to help identify the transparent areas of the logo. These
colored regions will not be captured but later displayed as transparent area.
Memorizing logos in the STE200 with an Analog Way Controller
1. In the Input Selection section, press the source button (#1 to #12) of the source you wish to record as a
logo. Please take this source.
2. Select the Logos/Frames menu.
3. Select Record Logos in the Logos/Frames menu. A small white rectangle will appear on your main display,
indicating the logo that will be captured.
4. Adjust logo size, position, and fine tune key attributes to memorize logo settings.
5. Select an empty logo memory (empty logos are indicated in the sub-menu) to store the logo into. The
STE200 will display a progress status bar on the VFD screen.
6. In the Layer Selection section, press the [LOGO # 1] button, and select logo number (#1 to #4) you wish
to use. Your logo will appear on the preview screen above any existing layer on screen.
7. Press the [TAKE] button. Your logo will appear on the main display.