Analog Way Smart Edge User Manual
Page 30
28
Once your inputs all have been configured, the output settings of the
STE100
must be set according to the
machines plugged into your
STE100
outputs (#1 and #2) (video projector, preview monitor...).
* NOTE *: If you want to use HDCP content from your sources, be sure to attach HDCP compliant screens or
projectors. If it’s not the case, the output image could be disabled.
1. In the Menu section, press the
[EXIT/MENU]
button and select Output in the menu by rotating the scroll
knob. Then press the
[ENTER]
button to enter the Output sub-menu.
2. In the Output menu, select the output type, resolution and frequency, to match the viewing hardware plugged
into the
STE100
, by rotating the scroll knob (see also Output Specifications p.14). Then press the
[ENTER]
button to enter each of the output parameters.
* NOTE *: Be sure to press the [ENTER] button to confirm every selected setting, the STE100, will revert to its
original settings if new choices are not confirmed.
3. Press the
[EXIT/MENU]
button to return to the main menu.
The Output menu also allows you to generate test patterns. The test patterns available through the Output
menu let you quickly and reliably setup your projectors.
1. In the menu section, press the
[EXIT/MENU]
button and select Output in the menu by rotating the
corresponding knob. Then press the
[ENTER]
button to enter the Output sub-menu.
2. In the Output sub-menu, select the Test Pattern menu. Press the
[ENTER]
button to enter the Test Pattern
menu. Choose the test pattern you wish to use in the Test Pattern menu by rotating the scroll knob, and press
[ENTER]
. The chosen test pattern will immediately appear on the selected output(s).
3. Press the
[EXIT/MENU]
button twice to return to the main menu.
* NOTE *: Be sure to turn the test pattern off to display your sources again.
* NOTE *: Beware any change in the output format requires a confirmation by the [TAKE] button. Then the
selected source will be changed with the correct aspect ratio.
Source output selection
Output selection settings