Datamax-O'Neil I-Class Peel and Present Option - Manual (Page 8)

6
Periodic Maintenance
The Peel Mechanism Rollers will need to be disassembled and cleaned approximately every 100,000
inches to ensure trouble free operation. This cleaning interval may be more or less depending on the type
of adhesive on the back of your media. Heavy or “gummy” adhesive will require more frequent cleaning.
Upper Rollers:
 Remove the Peel Mechanism from the printer.
Press in on the Latch and allow the Front Cover
to swing open.
 Remove the small C-Clip from the Upper
Roller Shaft.
C-Clip
Latch
Front
Cover
Upper Roller
Shaft
 Remove Upper Roller Shaft and associated
Rollers. Note the order of the Rollers as they
are removed, they must be re-installed in the
same order.
 Clean
all surfaces of the Rollers and the Upper
Roller Shaft. Isopropyl Alcohol can be used,
for heavy or stubborn deposits WD-40
or an
adhesive remover can be used. Be sure all the
ridges on the rollers are free of debris.
 Re-assemble the Upper Roller Shaft, Rollers,
and C-Clip into the Peel Mechanism Assembly.
Upper Roller
Shaft
Rollers