Datamax-O'Neil I-Class Peel and Present Option - Manual (Page 9)

7
Lower Rollers:
 Remove the Peel Mechanism from the printer.
Press in on the Latch and allow the Front Cover
to swing open.
 Push in on the Tab as shown, repeat for the
other side and then remove the entire Lower
Roller Assembly.
Push in on Tab
Lower Roller
Assembly
 Remove Lower Roller Shaft and associated
Rollers. Note the order of the Rollers as they
are removed, they must be re-installed in the
same order.
 Clean
all surfaces of the Rollers and the Lower
Roller Shaft. Isopropyl Alcohol can be used,
for heavy or stubborn deposits WD-40
or an
adhesive remover can be used. Be sure all the
ridges on the rollers are free of debris.
 Re-assemble the Lower Roller Shaft and
Rollers. Reinstall the assembly into the Peel
Mechanism Assembly.
Lower Roller
Shaft