Datamax-O'Neil I-Class Operator’s Manual User Manual
Page 24
14
I-Class
B. Route the Media under the Media Idler (also, if equipped over the Internal Rewinder;
and, if through the Rear Media Slot, over the Media Hub).
Media Idler
Media
Guide
Media
Sensor
Media
Internal Rewinder
(Optional Equipment)
Media
Hub
C. Pass the media through the Media Sensor then straight out the front of the printer.
D. Raise then slide the Media Guide over so that it rests lightly against the edge of the
media.
E. Position the Media Sensor; see Section 3.3.
F. If using thermal transfer media, load ribbon (see Section 3.3); otherwise, go to Step G.
G. Lower the Printhead Assembly and rotate the Printhead Latch into the locked position.
Close the cover then turn ON the printer. After READY is displayed, press and hold the
FEED Key until at least one label gap (or mark) is advanced; see Section 3.5.
Printhead Assembly
Printhead Latch
Note: Adjust the Leveling Cam if using narrow media; see Section 5.4.1.