Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 74)

64 I-Class
Standard Calibration (continued)
Step Action Displayed Message Comment
9 Observe the LCD.
GAP MODE
CALIBRATION COMPLETE

Or, for reflective media:

REFLECTIVE MODE
CALIBRATION COMPLETE

Or, for continuous media:

CONTINUOUS MODE
CALIBRATION COMPLETE

The calibration was
successful if
CALIBRATION COMPLETE
appears.
(If, however, another
message was displayed
see Note 1, below.)
10
Press the Key three
times to exit the menu.
Users of circular or
irregularly shaped die-cut
media see Note 2 before
proceeding.
If using gap, notch or
reflective media, press and
hold the FEED Key. Allow
at least one label to
advance from the printer
before releasing the key.
READY

The printer is ready.
If this calibration was
unsuccessful, go to
Section 5.2.2.
 Notes:
(1) WARNING LOW
BACKING is a normal
message when
calibrating notched media
or media with
transparent backing; see
Section 6.1.2 for other
possible messages.
(2) If using circular or
irregularly shaped die-cut
labels, reposition the
Sensor Eye Mark over the
widest part of a label.