Datamax-O'Neil M-Class Mark II DMXNet II Card Option - Manual (Page 13)

P r i n t e r ’ s I n t e r n a l W e b P a g e s 11
Wifi Configuration Page (continued…)
Advanced Settings
Maximum Transmission
Rate Specifies the Module’s maximum wireless transmission rate. Default is 2 Mbps.
Use Fixed Rate for
Transmission Sets the 802.11 behavior for Ad Hoc mode. Default is 0.
WLAN IP Settings
DHCP Displays the current DHCP mode status.
DHCP Fallback This is the IP address to use with DHCP is enabled and a DHCP server cannot be found.
Retain DHCP Values This instructs the wireless LAN to retain the latest DHCP provided IP address. This address
will be used in the event a DHCP server cannot be found on a subsequent restart.
Persistent DHCP This instructs the wireless LAN to copy the latest DHCP provided IP address to a static
address.
Enable MAC Cloning This instructs the wireless interface to assume the MAC address of the printer when
connecting to the wireless network.
DHCP Client Name Specifies the Module’s DHCP client name. This should be different than the NetBIOS name
specified on the TCP/IP page.
DHCP Fixed Interval
Retransmission Sets the DHCP retransmission mode to either Exponential (not checked) or Fixed interval
(checked). Default is not checked.
DHCP Retransmit
Interval Sets the DHCP retransmission interval to use when “Enable DHCP Fixed Interval
Retransmission” is set to fixed. This is an integer with a range of 1-64. Default is 15.
DHCP Acquire Time
Limit Sets the number of seconds the DHCP should attempt to acquire an IP address before
using the fallback IP address, if wl-dhcp-fb is on. An integer with a range of 1-255. Default is
150.
DHCP Fallback IP
Address Displays the fallback IP address. Default is 192.168.10.1
DHCP Fallback Subnet Displays the fallback subnet mask. Default is 255.255.255.0
DHCP Fallback Gateway Sets the fallback gateway address. Default is 0.0.0.0.
Static BSS Address Specifies the radio module’s static IP address; up to four octets separated by a period. If
Enable DHCP is checked, this parameter is ignored. Default is 0.0.0.0.
Subnet Mask Displays the radio module’s subnet mask; up to four octets separated by a period.
Default is 255.255.255.0
Default Gateway Displays the Module’s LAN IP address; up to four octets separated by a period.
Default is 192.168.0.1.
Primary DNS Displays the primary DNS server address for DNS lookups. If DHCP is enabled, the IP
address provided by the DHCP server is used.
Default is 0.0.0.0.
Secondary DNS Displays the secondary DNS server address for DNS lookups when the primary DNS server
is unavailable.
Default is 0.0.0.0.