Datamax-O'Neil M-Class Mark II DMXNet II Card Option - Manual (Page 5)

C a r d I n s t a l l a t i o n 3
Installing the Communication Card
1. Insert the two supplied Standoffs into the printer’s
Main Board as shown.
Standoffs
Main Board
2. Slide the Communication Card into the rear of the
printer. Align the two holes in the Communication
Card with the two previously installed Standoffs.
3. Press the Communication Card onto each of the
Standoffs.
4. Install the two previously removed cover plate
Screws.
Screws
Standoffs
Communications
Board
5. Install each end of the supplied Ribbon Cable into
its corresponding connectors on the printer’s Main
Board and Communication Card.
6. Re-install the printer’s covers and associated
screws.
Main Board
Communication
Card
Ribbon Cable