Datamax-O'Neil M-Class Mark II DMXNet II Card Option - Manual (Page 3)

C a r d I n s t a l l a t i o n 1
Overview
This document describes the installation and use of the DMXrfNetII and DMXNetII Card options for the M-Class Mark II
printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the
option. Keep this documentation for future reference.
CAUTION
For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the printer’s power
cord before beginning this installation.
Contents of the Communication Card Kit
This kit contains the following items:
Communication Card
Antenna (wireless models)
Ribbon Cable
Standoffs
Follow the steps below to install these items into the printer If
your card is already installed proceed to the Overview section .
Tools Required
To install this option you will need a #2 Phillips head screwdriver.

Only qualified service personnel should install this Option.
Step 1: Preparing the Printer
1. Turn ‘Off’ the power switch and unplug the printer.
2. Open the cover. Remove any installed media/ribbon
from the printer.
3. Remove the single Screw on the rear of the printer
and remove the two Screws securing the side cover.
Screws