The burner is operating but the radiators are cold, The domestic hot water does not appear hot enough – DE DIETRICH SOLNEO SGC 24 SOL User Manual

Page 16

Advertising
background image

16

SGC 24 SOL

15/10/2009 - 300017555-001-C

6. Troubleshooting

6.3.2

The burner is operating but the radiators are cold

„

Air and water noise in the radiators

`

Bleed the radiators.

`

Top up the heating circuit with water.

`

If it is often necessary to top up the installation with water,
contact your fitter.

`

If the problem persists, consult your fitter.

„

The burner is operating but the radiators are cold

`

Check that the boiler heating pump is operating correctly.

`

If the problem persists, consult your fitter

6.3.3

The domestic hot water does not appear hot enough

„

Flow of water from the tap too high.

The higher the flow, the lower the temperature.
`

Reduce the flow from the hot water tap.

`

If several draw-off points are open at the same time, close one
or other of the points.

6.3.4

Hot water takes a very long time to reach certain draw-off points and not others

This is due to the length of the hot water pipes between the draw-off
points and the boiler.
The greater the length, the longer the time necessary for the hot
water to replace the colder water in the pipes.

Advertising