Emtek Thumb by Lever_Knob - Manual

1. Install Mortise Lock 3. Install Key Cylinder
Installation Guide - UL Mortise Thumb by Lever/ Knob
4. Tighten Key Cylinder
2. Mount Inside and Outside Trim to Door
Tighten lever
with 3/32
hex wrench
(provided).
IN4-ULMORTHBLVKB REV. 03-15-2013
See template for door
prep specifications.
Outside
Outside
1. Install Security Plate
Inside
Inside
5. Install Trim Plate 6. Tighten Inside Lever or Knob
Install key cylinder by
threading it clockwise
on to trim plate.
Trims and grips will vary
depending on style.
For bottom
grip assembly.
2. Install Dust Box 3. Install Strike Plate
Face plate can be
adjusted for door
bevel up to 3-1/2 deg.
After key cylinder is installed, secure
cylinder by tightening screw with 9/64 hex
wrench (provided).
See template for door
jamb prep specifications.
Fasten security strike to door jamb
with #10 x 3 wood screws (provided).
Dust box slips into
security strike.
#12-24 self
taping screws
(provided).
TIGHTEN
SCREW
CLOSEST TO
OUTSIDE EDGE
OF DOOR.
DO NOT OVER
TIGHTEN.
!
Outside edge
of door.