EXP Computer CD Traveler Plus - Manual (Page 25)

- - 25
It is not necessary to remove the PCMCIA interface card from the CD-ROM
drive when the CD-ROM is in stand-alone mode. You may store the card in
the cardholder at the back panel of the drive.
The following control buttons will be used in stand-alone mode.
Power Button
•
Press the POWER button will turn on the PCMCIA CD-ROM in stand-alone
mode. Press the POWER button again will turn off the drive.
•
The PCMCIA CD-ROM will spin in a lower speed (single speed) in stand-
alone mode.
•
As another power saving feature, the PCMCIA CD-ROM will be
automatically turned off if it has not played for approximately 40 seconds.
Play/Pause Button
•
Press this button will activate the drive to begin playing.
•
If the drive is in play state, pressing this button will make it pause.
•
This button will work in the audio CD playing mode only..
Next/Previous Button
•
In the play state, press the right edge of the button to skip to the next track.
•
Press the left edge of the button to skip to the previous track.
•
This button will work in the audio CD playing mode only..
Volume Control Knob
•
Use this knob to adjust the headphone volume.