EXP Computer CD Traveler Plus - Manual (Page 40)

- - 40
The example above shows the default setting. The /D: switch indicates
the device name. It MUST be the same name as you specified by the /D:
switch of EXPCDI.EXE in your CONFIG.SYS file. The /M: switch
indicates how much memory to allocate for caching information on the
CD-ROM. The default /M:4 caches 8KB.
For more information about the switches of MSCDEX, please type “help
MSCDEX” at the DOS prompt.
5. Now, reboot your computer to activate the CD-ROM drive.
PARALLEL PORT Interface
Make sure that your computer has an IBM-compatible parallel
(printer) port and DOS 3.1 or above.
1. Follow the instruction on the HARDWARE INSTALLATION section.
2. Place your installation diskette into the floppy drive. (Open a “DOS
prompt” if you are in the Windows environment.)
If the floppy drive is the A drive, enter a:\tcd
If it is the B drive, enter b:\tcd
3. Perform option 1, "Install", from the Utility Main Menu.
******** CD Utility Main Menu ********
1. Install TransCD Software
2. Un-install TransCD Software
3. Audio CD Utility
4. Print TCD.EXE version number
5. Re-boot system
6. List all TransCD devices
7. List all parallel devices
8. Reset CD-ROM drive
0. Exit
Enter menu selection >> 1
4. Follow the instructions on the screen. For the quickest install, press
ENTER to use drive C, press Y and ENTER to use default, and then