FlexLink X45 - Manual (Page 7)

Installation
4 5113270
4 Installation
With this accessories kit the software with all the appropriate files are in-
cluded.
In order to make the parameter software to work properly follow these
steps:
1 Copy the folder called F-ECO to the target computer.
2 Kvaser leaf light – USB CANopen cable
Please install the drivers then install your Kvaser hardware:
• Run the driver installation program and follow the on-screen in-
structions
• Plug in your Kvaser hardware
• The found New Hardware Wizard will detact and install your kvas-
er hardware
• Confirm hardware installation by opening the Control Panel applet
“Kvaser Hardware” and checking that your hardware is in the list.
Here you can also check the hardware´s firmware version to de-
termine if an update is available.
After this you can use the cable but only using this USB port. If the cable is
connected to another port these steps has to be completed all over again.
3 Parameter software
The next step is to install the parameter software. Double click on the fol-
lowing file:
…l\F-ECO\feg_exe\lvrte\lv86runtime.msi and follow the instruction to com-
plete the installation
After this step you are asked to reboot your system.