Brooks Instrument SolidSense II - Manual (Page 26)

Installation and Operation Manual
X-SolidSense II-PT-eng
Part Number 541B160AAG
July, 2011
2-10
Section 2 Installation
SolidSense II ® Series
2-10-2 Zero Adjustment (ATEX SolidSense II Pressure Transmitters Only)
On ATEX SolidSense II pressure transmitters, the zero adjustment screw is
located underneath the access cover nut as shown in Figure 2-10(A-B).
Unscrew the access cover by turning it in a counterclockwise direction with
the electrical connector pointing upward. The cover should drop down after
five complete revolutions.
Figure 2-10 Location of the Zero Adjustment Screw on the
(ATEX SolidSense II Pressure Transmitters)
Access Cover
Nut
A B
Zero Adjustment
Screw