Burkert Type 6144 - Manual (Page 20)

20
07 ATEX 2048
English
Maintenance
11. MAINTENANCE
DANGER!
Risk of injury due to malfunction/escape of medium.
If the exhaust air from other processes is used to generate com-
pressed air for the device, the seals may be destroyed by the
media contained in the air.
• Use only fresh air to generate compressed air for the device.
The flipper valve type 6144 is maintenance-free if the operating condi-
tions described in this manual are observed
11.1. Error correction
In the event of malfunctions, make sure that
→
the device has been installed according to the specifications,
→
the connection has been established properly,no technical direct
voltage has been used (see chapter „Electrical installation“)
→
and that the device is not damaged.
Check the following:
→
the line connections and the operating pressure
→
the power supply, valve control and the free flow of the pipelines.
12. PACKAGING, TRANSPORT,
STORAGE
NOTE!
Transport damages!
Inadequately protected equipment may be damaged during
transport.
• During transportation protect the device against wet and dirt in
shock-resistant packaging.
• Avoid exceeding or dropping below the allowable storage
temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature -40 ... +55 °C.
13. DISPOSAL
NOTE!
Damage to the environment caused by device components
contaminated with media.
• Dispose of the device and packaging in an environmentally
friendly manner.
• Observe applicable regulations on disposal and the
environment.