Burkert Type 8611 - Manual (Page 16)

16
Assembly
7.3.1. installation in a control cabinet
• Prepare control panel recess with the dimensions 45mm x 45mm
(corner radius 3mm).
• Place the supplied seal on the housing.
• Insert the controller from the front into the control panel recess.
• From the rear, snap the 4 supplied fastening elements into place
and fasten using a screwdriver.
4 Fastening elements
Seal
Fig. 7: Installation elements Fig. 8: Installed controller
recommended line cross sections for the control cabinet
model:
Cross
section
min. Cross
section
max.
Minimum
length
Cross section for
flexible lines 0.2 mm² 1.5 mm² 10 mm
(stripping)
Cross section for
flexible lines with
cable end sleeve
without plastic
sleeve 0.25 mm² 1.5 mm² 10 mm
Cross section for
flexible lines with
cable end sleeve
with plastic sleeve 0.25 mm² 0.75 mm² 10 mm
Tab. 3: Recommended line cross sections
english
Type 8611