Burkert Type 8635 - Manual (Page 96)

94 - 8635
O
PERATING THE
P
ROCESS
C
ONTROLLER
(S/HART)
P.CO - PARA
Parameters of the PID process controller
Amplification factor of the process controller
0 ... 99.99 (factory setting 1.00)
Operating point
0.0 ... 100 % (factory setting 0 %)
Rate time
0 s ... 999.9 s (factory setting 0 s)
Reset time
0.5 s ... 999.9 s (factory setting 999.9 s)
NOTE The parameters that were entered should be noted in the table in Appendix Tables for
process controller.
For definition of the parameters of a PID controller, see Appendix General Rules.
For self-parametrization of the PID parameters, see step .
P.CO - SETP
Type of setpoint setting (internal / external)
Setpoint setting internally via the keys on the SIDE
Control
(S/HART).
Setpoint setting externally via the standard signal
input.
P.CO SETP
SETP INT
SETP EXT
P.CO PARA KP XX.XX
TN XXX.X
TV XXX.X
XO XXX