Burkert Type 8640 - Manual (Page 19)

19
Start-Up
8. START-UP
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
• Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/
the device.
NOTE!
• Switch on the supply pressure.
• Only then switch on the power supply!
Procedures before fluid start-up:
→
Check connections, voltage and operating pressure.
→
Ensure that max. operating data are not exceeded.
→
Check correct assignment of the connections 1 and 3 or 5. They
may by no means be interchanged.
→
Release manual actuation during electrical operation.
9. MAINTENANCE
See “7.2. Fluid deinstallation”, page 15.
10. TRANSPORT, STORAGE, DISPOSAL
NOTE!
Transport damages!
Inadequately protected equipment may be damaged during transport.
• During transportation protect the device against wet and dirt in
shock-resistant packaging.
• Avoid exceeding or dropping below the permitted storage
temperature.
Incorrect storage may damage the device!
• Store the device in a dry and dust-free location!
• Storage temperature: -20 ... +60 °C.
Damage to the environment caused by device components
contaminated with media!
• Ensure the device and packaging are disposed of in an environ-
mentally sound manner.
• Observe applicable regulations relating to refuse disposal and
the environment.
• Observe the national waste disposal regulations.
english
Type 8640