Burkert Type 3005 - Manual (Page 25)

25
Installation
control signal when current 0 ... 20 ma
R
→
Press <MEM> and <OPEN> push-
buttons and switch on the card (hold
down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <OPEN> push-
buttons and disconnect the card from
the power supply.
control signal when current 4 ... 20 ma (preset)
R
→
Press <MEM> and <CLOSE>
push-buttons and switch on the card
(hold down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <CLOSE>
push-buttons and disconnect the
card from the power supply.
learning mode
specify end positions
G R
→
Press <OPEN> and <CLOSE>
push-buttons and switch on the
card (hold down push-button).
The RED and the GREEN LED’s light
up.
→
Release <OPEN> and <CLOSE>
push-buttons.
Both LED’s go out.
Learning mode is selected.
R
→
Press <CLOSE> push-button to
move the shut-off valve into the
closed position.
The RED LED lights up.
R
→
Press <MEM> and <CLOSE>
push-buttons to save the closed
position.
The RED LED lights up 2x.
G
→
Press <OPEN> push-button to
move the shut-off valve into the
open position.
The GREEN LED lights up.
english
Type 3005