Burkert Type 7616 - Manual (Page 12)

12
Start-Up
reversal of the flow direction
To reverse the flow direction, exchange the control of valve 1 and
valve 3 (For valve configuration, see figure "Installation").
electrical connection 7.5.
Connection type: Rectangular
connector stranded wire 200 mm
(Other designs on request).
Note the voltage as specified on the type plate!
Connect the device electrically.
→
The individual valves must be activated consecutively (refer
to the control diagram in chapter "Start-up / Functions").
sTarT-up 8.
safety instructions 8.1.
Warning!
risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
Before start-up, ensure that the operating personnel are familiar •
with and completely understand the contents of the operating
instructions.
Observe the safety instructions and intended use.
•
Only adequately trained personnel may operate the equipment/ •
the device.
adjusting the stroke volume 8.2.
Adjustment screw
Fastening screw
adjustment of the flow rate
Reduce flow rate
Increase flow rate
Turn clockwise Turn anticlockwise
Adjustment stroke volume Fig. 5:
english
Type 7616