Burkert Type 8136 - Manual (Page 14)

> 200 mm
(7.87")
Fig. 7: Mounting of the radar sensor on round vessel tops
In vessels with conical bottom it can be advantageous to mount the
sensor in the center of the vessel, as measurement is then possible
down to the lowest point of the vessel bottom.
Fig. 8: Mounting of the radar sensor on vessels with conical bottom
Do not mount the instruments in or above the filling stream. Make sure
that you detect the product surface, not the inflowing product. Inflowing medium
14 LEVEL TRANSMITTER 8136 • 4 … 20 mA/HART - two-wire
4 Mounting
41783
-EN
-120316