Hydra-Tech S6200 User Manual
8” hydraulic submersible, Features, Model s6200
MODEL S6200
8” (200 mm) Discharge
8” HYDRAULIC SUBMERSIBLE
HIGH PERFORMANCE,
SOLIDS HANDLING PUMP
The S6200 is a Highly Efficient Solids
Handling Effluent Pump for use on jobs
such as Waste Lagoons, Sewer By-Pass,
Barge Transfer, Municipal Lift Stations
and Tank Pumping.
FEATURES
B0109
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
:
WEIGHT:..................................................... 715 lbs. (324 kg)
HEIGHT:............................................................ 41" (104 cm)
WIDTH (@ widest point):................................. 28.5" (72 cm)
DISCHARGE:....................................... 8", 125# ASA Flange
INLET:.................................................. 8", 125# ASA Flange
SOLIDS HANDLING:........................................ 4" (100 mm)
HOSE PORTS:......1-1/4" Code 61 Flange or 1-1/2" NPT (F)
PUMP BODY:......................................................
Ductile
Iron
IMPELLER:.......................................................... Ductile Iron
WEAR RING........................................................ Ductile Iron
SHAFT:.............................................17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................ Max 90 GPM (340 LPM)
OPERATING PRESSURE:............. Max 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice
•
Balanced High Efficiency Two Vane
Closed Channel Impeller
•
Will pass 4" (100 mm) semi-solids
•
Variable Speed hydraulic drive provides
a wide range of performance
•
Oil Lubricated Seals (can run dry)
•
High Efficiency Balanced Vane
hydraulic motor
•
Can be bolted directly into a pipeline or
used as a booster pump
•
Safe Hydraulic Drive can be used where
electric power is hazardous or
impractical
•
Operates with our HT100 to HT200
power units or other hydraulic power
sources capable of flows of 50 - 90 GPM