Hydra-Tech S6TCAL - Manual

MODELS:
S6TC
(Ductile Iron Body)
S6TCAL
(Aluminum Body
6” (150 mm) Discharge
6” HYDRAULIC SUBMERSIBLE
TRASH PUMP
The S6TC is a 6" discharge trash
pump designed specifically to easily
pass through a 22" manhole. The
S6TC uses a high efficiency two
channel impeller with adjustable
wear surface. It is available with a
durable ductile iron or lightweight
aluminum casing.
FEATURES
D0413
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
: www.hydra-tech.com E-Mail : [email protected]
WEIGHT: S6TC.......................................... 270 lbs. (122 kg)
S6TCAL....................................... 175 lbs. (80 kg)
HEIGHT:............................................................. 34" (86 cm)
WIDTH (@ widest point):............................. 20-3/4" (53 cm)
DISCHARGE:....................................................... 6" NPT(F)
INLET FLANGE:............................................. 6" 125# ANSI
SOLIDS HANDLING:.......................................... 3" (75 mm)
HOSE PORTS:................................................ 1" (-16) SAE
PUMP BODY: S6TC........................................... Ductile Iron
S6TCAL......................................... Aluminum
IMPELLER:........................................................ Ductile Iron
WEAR RING...................................................... Ductile Iron
SHAFT:........................................... 17-4 PH Stainless Steel
SHAFT SEAL:.................................. Carbon / Ceramic (Std)
Silicon Carbide (Opt)
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:............................... Max. 28 GPM (106 LPM)
OPERATING PRESSURE:............. Max 2900 PSI (197 Bar)
POWER SOURCE:...... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice
•
High Efficiency Closed Channel Impeller
(will pass 3" semi-solids)
•
Compact Design allows this pump to fit
through a 21” opening
•
Variable Speed hydraulic drive provides a
wide range of performance
•
Oil Lubricated Seals (can run dry)
•
Adjustable Wear Ring
•
Can be bolted directly into a pipeline or
used as a booster pump
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Operates with our HT35 to HT60 power
units or other hydraulic power sources
capable of flows to 28 GPM
S6TC
S6TCAL