User programming mode & flow chart – Hydrotech 6700 XTR Valve Upflow Automatic Water Softeners Service Manual User Manual
Page 17
Page 17
User Programming Mode & Flow Chart
NOTE: Depending on current option settings, some displays cannot be viewed or set.
NOTE: Depending on current option settings, some displays cannot be viewed or set.
Enter User Mode
— Press and hold the Up and Down buttons for 5 seconds.
Set Feed Water Hardness
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers..
— Press the Extra Cycle button to proceed to the next step..
NOTE: Feed Water Hardness will not be shown in Volume Override or Time Clock system types.
Set Regeneration Day Override
— To turn on and set the days, press the Down button..
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers..
— Press the Extra Cycle button to proceed to the next step.
Regeneration Time
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers..
— Press the Extra Cycle button
End of User Programming Mode
1.
2.
3.
4.
5.
Entering User Mode:
Press and hold the Up and Down.
buttons for 5 seconds.