Hydrotech 5600 SXT User Programming Chart - Manual

8/7/08
SOFTENERS AND IRON FILTERS
Model 5600 SXT-User Programming Chart
Time of Day
FROM SERVICE MODE:-
•
To set Time of the Day push and hold or button for 5 seconds
(*Not both Up and Down Buttons)
Display is TD (Time of Display) → → → → Press
or button to adjust the
display time.
Press Extra Cycle button to resume normal operation
Model 5600 SXT -User Programming Chart
FROM SERVICE MODE:-
• To set user programming push and hold and buttons for 5
seconds, and the time of day is NOT set to 12:01 PM.
Display is DO (DAY OVERRIDE) → → → → [factory default setting: OFF]. Press UP/DOWN
buttons to adjust the setting.
↓ ↓ ↓ ↓
↓ ↓ ↓ ↓
Display is RT (REGENRATION TIME) ([default:
For Iron Filters - 11:00 P.M.
For Softeners – 2:00 A.M.]
Press UP/DOWN buttons to adjust the time.
↓ ↓ ↓ ↓
↓ ↓ ↓ ↓
Display is H (FEED WATER HARNESS) [grains per gallons default: Softeners - 15].
Iron content ppm per gallon default: Iron Filters - 20
Press UP/DOWN buttons to adjust the value. NOT AVAILABLE IF THE VALVE TYPE
IS SET TO FILTER IN MASTER PROGRAAMING.
↓ ↓ ↓ ↓
↓ ↓ ↓ ↓
Display is RC (FIXED RESERVE CAPACITY) [Fixed reserve capacity in gallons default:
0]. Press UP/DOWN buttons to adjust the value.
↓ ↓ ↓ ↓
UP DOWN
UP DOWN
Extra Cycle
Button
Extra Cycle
Button
UP DOWN
Extra Cycle
Button
Extra Cycle
Button
42133