Hydrotech 5600 SXT User Programming Chart - Manual (Page 9)

↓ ↓ ↓ ↓
Display is D (DAY OF WEEK) → → → →used to set the day of week in which the regeneration should
occur [Factory Setting: OFF]. Press UP/DOWN buttons to adjust the setting. ONLY
AVAILABLE IF CONTROL TYPE IS SET TO DAY OF WEEK SETTING.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is CD (CURRENT DAY) → → → → used to set the current day of week in which the
regeneration should occur Press UP/DOWN buttons to adjust the setting. ONLY AVAILABLE
IF CONTROL TYPE IS SET TO DAY OF WEEK SETTING.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is FM (FLOW METER TYPE)→ → → → [Factory Setting: t0.7].Do not change this setting.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
RETURN TO SERVICE
Model 5600 SXT-Diagnostics Chart
To enter the diagnostic mode, push and hold and button for 5 seconds.
Display is FR (CURRENT FLOW RATE)→ → → → display current flow rate in gallons per minutes.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is PF (PEAK FLOW RATE)→ → → → display peak flow rate in gallons per unit since the last
regeneration cycle.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is HR (HOURS IN SERVICE)→ → → → display to view the hours in service since the last
regeneration cycle.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is VU (VOLUME USED) → → → →display the volume in gallons used since the last
regeneration cycle.
↓ ↓ ↓ ↓
Extra Cycle
Button
Extra Cycle
Button
Extra Cycle
Button
UP
UP Extra Cycle
Button
UP
UP
UP