Hydrotech 5600 SXT User Programming Chart - Manual (Page 2)

↓ ↓ ↓ ↓
Display is CD (CURRENT DAY OF THE WEEK). Press UP/DOWN buttons to adjust the
current day of the week. ONLY AVAILABLE IF DAY OF THE WEEK CONTROL IS
ON IN MASTER PROGRAAMING
Model 5600 SXT- Master Programming Chart
FROM SERVICE MODE:-
•
To enter master programming mode, set the Time of Day display to 12:01 P.M.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Press and hold and buttons together until the programming icon
replaces the service icon
Display is DF (DISPLAY FORMAT) → → → → Unit of measure for volume and display format for
time [Factory Default Setting: GAL]. Press UP/DOWN buttons to adjust the settings.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is VT (VALVE TYPE) → → → → type of valve setting [Factory Setting: St1b (Standard
Downflow/Upflow, Single Backwash]. Press UP/DOWN buttons to adjust the settings.
↓ ↓ ↓ ↓
↓ ↓ ↓ ↓
Display is CT (Control Type)→ → → → type of regeneration [Factory Setting: Fd (Meter Delayed)].
Press UP/DOWN buttons to adjust the settings.
↓ ↓ ↓ ↓
↓
↓ ↓ ↓
Display is NT (Number of Tanks)→ → → → [Factory Default Setting: 1]. Do not change the setting.
↓
↓ ↓ ↓
↓
↓ ↓ ↓
Display is UNIT CAPACITY → → → → Capacity in grains for softeners and in ppm per gallon for iron
filters. [Factory Default Setting: Refer to User
Manual].
Extra Cycle
Button
Extra Cycle
Button
Extra Cycle
Button
Extra Cycle
Button
Extra Cycle
Button
UP DOWN