Clear-Com RS-602 (No longer available) - Manual (Page 48)

R S - 6 0 2 / 6 2 2 B E L T P A C K 4 2
To rotate the beltclip to a new position:
1. Remove the setup help label and the two retaining screws.
2. Rotate the beltclip 90
o
or 180
o
as desired.
3. Replace the screws.
The label on the beltclip is not reusable and must be replaced. You
can order a replacement label from your distributor or from the
factory.
Use the same procedure for replacing a broken or damaged beltclip.
CLEANING
To clean the surface of your beltpack, use a damp cloth and mild soap.
Remove all soap residue and excess moisture before returning to
service.
TROUBLESHOOTING
PROBLEM Low audio level.
CAUSE Multiple terminations on the line. Excessive
capacitance and/or resistance due to cable
length and/or gauge.
SOLUTION If connected to more than one main station
or power supply, check that there is only one
termination per channel.