Clear-Com IF4W4 User Manual
Clear-Com Accessories communication
Advertising
Table of contents
Document Outline
- Contents
- Important Safety Instructions
- Operation
- Introduction
- Description
- Operation
- Null Adjustment
- 1. Connect a TS1 earphone or a four pin XLR headset (for monitoring the test tone provided with the interface) into the ‘Null Monitor’ connector on the front panel.
- 2. Push the appropriate test null button for the channel to be nulled. A tone will be audible to help null the circuit.
- 3. Turn the R, L and C null control in either direction until a decrease in audible tone is observed. Continue to adjust the controls until the tone has become inaudible.
- 4. Make fine adjustments by going back a couple of times over the R, L and C adjustments for a complete null.
- 1. Check for proper termination of the line.
- 1. Connect a TS1 earphone or a four pin XLR headset (for monitoring the test tone provided with the interface) into the ‘Null Monitor’ connector on the front panel.
- Receive Level Adjustment
- Transmit Level Adjustment
- LED Threshold
- Null Adjustment
- Installation
- Technical Specifications
- Limited Warranty