Clear-Com Eclipse-PiCo - Manual (Page 44)

Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual
4 - 6
Figure 4-4: Wiring Matrix to Digital Panel Using RJ-45
WIRING GENERAL-PURPOSE OUTPUTS
The DB-25 connector labeled “GP OUT” allows connection to the
Eclipse PiCo matrix’s eight double-pole double-throw (DPDT) relays
with contact ratings of 30 VDC at 1A.
Each general-purpose output has a relay inside the Eclipse PiCo
matrix. When a general-purpose output is inactive, the associated
“common” pin on the GP OUT connector will be shorted to the relevant
“normally closed” pin. When a general-purpose output becomes active,
the short between the “common” pin and the “normally closed” pin is
broken and a new connection is made between the “common” pin and
the “normally open” pin.
Pair 2
Pair 1
Pair 3
Pair 4
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Matrix Frame End
ATT-T568B (Modular Jumpers Wired One to One)
Panel End
No Connection (NC)
No Connection (NC)
No Connection (NC)
Multiplexed Data/Audio
Multiplexed Data/Audio
No Connection (NC)
No Connection (NC)
No Connection (NC)
4