Clear-Com ICS-2003 - Manual (Page 5)

U P G R A D I N G T H E F R O N T - P A N E L D I S P L A Y O N T H E I C S - 2 0 0 3
5
INSTALLING THE NEW FRONT-PANEL ASSEMBLY
Install the panel microphone bushing on the new front panel. Reinstall the black plastic microphone
connector in the microphone bushing. Use the 1/4-inch nut driver to install the two nuts that hold
the headset microphone connector in place. 1
STEP
panel microphone bushing
black plastic panel
microphone connector
1/4-inch nuts
1 of 4 #8 plastic hex nuts
1 of 4 #8 plastic screws
Install the speaker on new circuit board by securing the four #8 plastic screws
into the four #8 plastic hex nuts as shown. Use the 11/32-inch nut driver to tighten,
to avoid damaging the speaker. 2
STEP
speaker speaker circuit board