Clear-Com WTR-680 User Manual

Page 31

Advertising
background image

Pre-Walk-Thru Check list

Fol low ing the in struc tions fully to this point you have suc cess -
fully com pleted the fol low ing check list:

❒

Lo cated the base sta tion prop erly.

❒

Con nected power to base sta tion.

❒

Con nected the 1/2-wave an ten nas to the base sta tion.
Checked fre quency range of the an ten nas with the fre -
quency of the base sta tion by cor rectly match ing color
codes.

❒

Con nected 1/4-wave an tenna to the beltpack. Checked
fre quency range of the an ten nas with the fre quency of
the beltpack by cor rectly match ing color codes.

❒

Base sta tion trans mit power switches in the cor rect po -
si tions.

❒

Trans mit mode switch on beltpack set cor rectly

❒

Set wired in ter com type cor rectly.

❒

Con nected head sets to base sta tions (if needed) and all
beltpacks.

❒

Con nected the base sta tion to any aux il iary au dio, in -
ter com, ex

ter nal P.A. sys tem, or re

lay con tact de

tect

cir cuit if needed

❒

In stalled bat ter ies in the beltpack.

❒

If you missed any of the above in struc tions, go back
and com plete that in struc tion be fore go ing on.

6-1

S

ection

6

Advertising
This manual is related to the following products: