Clear-Com BS850 (Last time buy) - Manual (Page 26)

23
Copy Beltpac Settings:
To copy settings from one Beltpac to all others
for all settings except ID numbers, names and
transmit frequencies, select Copy and press the
ENTER button.
Upload Beltpac Settings:
To upload all Beltpac settings from the base
station to a Beltpac, select a Beltpac then select
the upload box and press the ENTER button.
NOTE: A Beltpac must be connected to the
BELTPAC CONFIG connector on the base station
front panel to enable uploading of Beltpac settings.
To ensure new settings are properly activated, turn
the Beltpac off and disconnect it after uploading.
Saving and Loading Configurations
Save Configuration Settings to File:
To save your configuration settings to a file, select
the File number then select Save and press the
ENTER button.
NOTE: File number 1 is reserved for frequency
scans. Files can be saved to 2 through 10.
Be sure to save any changes before turning a base
station off. Files are not automatically saved
when the power is turned off.
The last file used before a base station is turned
off will be used the next time the base station is
turned on.
Load Configuration Settings from File:
To load configuration settings from a previously
saved file, select the File number then select Load.
When the settings have been successfully loaded,
Ready will be replaced by Busy, then Success.
File 1 always contains the results (and other settings
present at the time) of the last frequency scan.
After loading settings, that file becomes the current
file and will be used again if the power is turned off.
NOTE: After loading a different configuration
file, be sure to upload new settings to all Beltpacs.