Hach-Lange ORBISPHERE 6110 OPC Instruction Manual - Manual (Page 13)

Note: The package must be created directly on the 6110 instrument, or through a web browser connected to the
6110 web server. It cannot be created using the OPC link
"Messages.Message In.Show" item
This item shows the specified message on the instrument.
"Messages.Messages Out.State" item
This output item indicates when the package can be changed for a new measurement analysis.
State value Stet description
Ready The package ID can be set in order to start a
measurement analysis.
Note: Check the "Message Out.Errors" item to check if the
analysis is able to start (see
"Messages.Message Out.Errors"
item on page 11).
Busy The system is busy (e.g. measurement in progress,
configuration being edited, etc.), preventing a
measurement analysis being started.
"Messages.Message Out.Errors" item
This output item provides information about any error(s) associated with the system. An error
prevents the instrument from running a measurement analysis. The instrument requires attention to
correct the fault. This is a flag field where the indicated value is computed by the addition of all active
errors.
Error value Error description
0x00000000 No error
0x00000001 EC board
0x00000002 ADIO board
0x00000004 CTRL board
0x00000008 O2 sensor
0x00000010 O2 sensor residual
0x00000020 O2 sensor noisy
0x00000040 TC chip
0x00000080 Temperature sensor
0x00000100 Flow sensor
0x00000200 Pressure sensor
0x00000400 Foam detector
0x00000800 Electrovalves
0x00001000 Motor
0x00002000 Ultrasound
0x00004000 Protection cover
0x00008000 Front door
0x00010000 Emergency stop
0x00020000 Sensor status
English 11